Hager Controls Bp 10140 Manual =link= <Verified Source>

Emphasizes that the device must be installed by a qualified electrician according to national standards. It warns that the device is not suitable for safe disconnection from the mains supply. Design and Layout:

The digital timer acts as an automated single-pole, double-throw (SPDT) switch. Connect the lines carefully using the screw terminal numbers on the housing: Powering the Timer (Control Supply) Connect the (typically blue) to terminal N .

Shut off the main breaker before handling the DIN rail or exposed wires. hager controls bp 10140 manual

Ensure the mode selector is set to the Automatic (Watch Symbol) position for the timer to run. Power Failure:

35mm DIN Rail execution (DIN EN 60715) inside distribution boxes Emphasizes that the device must be installed by

: Clean your modular hardware using a completely dry natural fiber or lint-free microfiber fabric. Physical Installation & Terminal Wiring Steps

Navigate to PROGRAM > MODIFY . Scroll through your saved steps, select the one you wish to change, adjust the parameters, and press OK . Connect the lines carefully using the screw terminal

Based on Hager’s naming conventions:

Repeat the exact same sequence to create the corresponding command for your desired end time. 3. Using the External Program Key (Save & Load)

Tap the or - modifiers to choose the current year, then press OK .