Wlx-893u3 Manual ◉

Turn the power ON. Press and hold the "Clone" button (usually marked "OTB/OTC") for 3-5 seconds until the LED lights flash.

It utilizes USB 3.0 (USB 3.2 Gen 1), supporting transfer speeds up to 5 Gbit/s , which reviewers find sufficient for standard data recovery and backups. Typical Package Contents

The drive is spinning, but the computer does not recognize it.

Press the (One Touch Cloning - OTC) to start the process. Caution: All data on the target drive will be overwritten. 3. One-Touch Backup (OTB) Wlx-893u3 Manual

The front USB ports act as a hub, allowing you to connect peripherals like flash drives, mice, or keyboards directly through the dock. 5. Troubleshooting & FAQ

Connect the USB 3.0 cable between the docking station and your computer.

A: That is normal. The device uses the chipset’s generic identifier. Only the label on the plastic housing says “WLX-893U3.” Turn the power ON

When not in use, unplug the device and cover the open SATA/IDE slots to prevent dust from settling on the internal pin connectors.

The bundled CD contains legacy drivers. Use only if internet is unavailable:

: Fits both 2.5-inch and 3.5-inch SATA I/II/III HDDs and SSDs. Typical Package Contents The drive is spinning, but

: Features the One-Touch Cloning (OTC) / One-Touch Backup (OTB) button alongside a four-stage LED progress sequence matrix (25%, 50%, 75%, and 100%).

Insert your 2.5" or 3.5" drive into its respective slot. Align the internal pins to prevent mechanical stress. Ensure the storage drive seats completely flat against the base plate. User Manual - Dustin

: Compatible with 2.5-inch (44-pin) and 3.5-inch (40-pin) PATA drives. Standalone Disk Cloning