Instruction Manual For Motorola Radius Sp10 Extra Quality Official

Charge a new or fully discharged battery for 14 to 16 hours to ensure a complete charge cycle.

Rotate the Volume knob clockwise until you hear a click. The LED may flash briefly to indicate a successful power-on test.

Look for a label inside the battery compartment or on the chassis: Example: CH1: 464.500 RX / 469.500 TX (if duplex/repeater mode).

Release the PTT button to listen. Ensure the volume is high enough to hear incoming audio. 3. Programming & Customization

: Use a small non-metallic tool (like a toothpick) to set the 4 switches according to the frequency chart below. A switch in the ON (up or down, depending on labeling) position corresponds to "0" in programming tables, while "1" represents "OFF" . Instruction Manual For Motorola Radius Sp10

If your SP10 uses a Nickel-Cadmium (NiCad) battery, let the battery drain completely before recharging to prevent it from losing overall capacity. 3. Basic Operating Instructions Operating the Radius SP10 requires just a few simple steps. Turning the Radio On and Setting Volume Rotate the Volume Knob clockwise until you hear a click.

Speak clearly into the microphone grille on the front of the radio.

The Motorola Radius SP10 is not user-programmable via a keypad. It requires internal crystal installation or a specialized Motorola programming jig and software (RSS), depending on the exact sub-model year. If you need to change frequencies to match other modern radios, contact an authorized two-way radio dealer.

Warning: Never operate the radio without an antenna attached. Transmitting without a load can burn out the internal power amplifier. Installing and Charging the Battery Charge a new or fully discharged battery for

The Motorola Radius SP10 relies on crystal or internal chip programming depending on the exact sub-generation of your model.

was released in two primary synthesized models tailored for different range and frequency needs:

Large button on the side. Press and hold to transmit your voice, and release to listen. LED Status Light:

If you charge the battery after only 10 minutes of use, it "forgets" its remaining capacity. To fix this: Look for a label inside the battery compartment

When a signal is received on your programmed frequency, the radio will unmute automatically.

The Motorola Radius SP10 Go to product viewer dialog for this item.

Powered by a rechargeable Ni-Cad battery, offering approximately 8 to 13 hours of operation depending on the band and usage cycle. Weight & Size: Highly portable at roughly with dimensions of 5.27" x 2.50" x 1.23" www.condor2.com Key Features & Functions

Operates on VHF or UHF bands depending on the specific model. Common VHF frequencies include 151.625 MHz, 154.570 MHz, and 154.600 MHz.

The Motorola Radius SP10 Go to product viewer dialog for this item.