Browse
| Parameter | STK413-430 | STK430 | STK435 | STK441 | | :--- | :--- | :--- | :--- | :--- | | | 20W+20W | 10W | 7W | 20W | | Nominal Supply Voltage (Ucc nom) | - | 25V | 27V | 44V | | Max Supply Voltage (Ucc max) | 95V | 41V | 39V | 63V | | Quiescent Current (IccQ) | - | 60mA | 60mA | 60mA | | Frequency Response (BW) | - | 30Hz-20kHz | 30Hz-20kHz | 30Hz-20kHz | | Load Impedance (Ri) | - | 8Ω | 8Ω | 8Ω | | Total Harmonic Distortion (THD) | - | 0.02% | 0.02% | 0.02% | | Voltage Gain (Au) | - | 26dB | 26dB | 26dB |
Check the voltage on the standby/mute pin. If it is not biased correctly according to the datasheet specs, the IC will remain in a silent, low-power state.
The is a renowned hybrid IC (Integrated Circuit) designed by Sanyo (now part of ON Semiconductor) that delivers high-quality, high-power amplification for audio applications . It is part of the STK413-xxx series , a family of thick-film hybrid ICs designed to simplify the construction of high-fidelity stereo power amplifiers.
To prevent high-frequency oscillation (which can destroy the IC), a is required at the output pins. This usually consists of a 0.1µF capacitor in series with a 10Ω (2W) resistor, connected from the output to the ground. Common Application Challenges Thermal Management
), ensuring minimal DC offset voltage at the speaker terminal. 4. Output Stabilization (Boucherot / Zobel Network) stk413-430 circuit diagram
An effective STK413-430 circuit consists of the following functional blocks: DC decoupling capacitors (usually ) and input resistors to set input impedance.
substrate temperature, which allows for significantly smaller heat sink sizes.
Are you planning to from scratch, or are you troubleshooting an existing unit?
Control pin managed by a dedicated RC time-delay switch or microcontroller logic to pull down internal pre-drive biasing during power-up. | Parameter | STK413-430 | STK430 | STK435
Small electrolytic or film capacitors (typically
Dual-rail voltage shifting topology designed for thermal efficiency. ∘raised to the composed with power Rate of internal junction-to-case heat transfer. Max Operating Substrate Temp ∘raised to the composed with power
Includes a built-in muting circuit to eliminate "thump" or shock noise during power-up or switching.
Typically 50W + 50W to 100W + 100W (depending on VCC). Operating Voltage: Dual rail supply (±VCC). It is part of the STK413-xxx series ,
The table below, adapted from a compilation of STK-series ICs, provides a useful point of reference. However, note that the STK413-430 is more powerful, with sources indicating it is a operating on a split power supply. This means it can deliver up to 20 Watts of power per channel into a standard 8-ohm speaker load.
To help tailor this information for your project, pleaseIf you are doing repairs, what is the unit showing? Share public link
A heavy-duty diode bridge rectifies the AC. Massive smoothing capacitors (at least