Drag the PT-SWITCH-EMPTY from the Switches menu onto your workspace.
When building labs in Cisco Packet Tracer, you will not find a standalone device explicitly labeled "Media Converter" in the component toolbar. Instead, Packet Tracer requires you to use specific modular devices or multi-port switches to convert signals between copper and fiber.
Router> enable Router# configure terminal Router(config)# interface gig0/0 Router(config-if)# ip address 192.168.2.1 255.255.255.0 Router(config-if)# no shutdown Router(config-if)# interface gig0/0/1 Router(config-if)# ip address 10.0.0.2 255.255.255.252 Router(config-if)# no shutdown Router(config-if)# exit media converter in cisco packet tracer link
This is acceptable for educational and design verification tasks because Packet Tracer verifies (ping, traceroute, routing protocols) not physical signal conversion.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Drag the PT-SWITCH-EMPTY from the Switches menu onto
The primary role of this device is "link conversion" rather than data processing.
After a few seconds, the links will turn green. If you share with third parties, their policies apply
This is the critical part. You cannot use automatic cable selection. You must manually choose the correct cable types.
It is commonly used to extend a network beyond 100 meters (copper limit) using fiber.
Fiber interfaces often operate at Gigabit speeds (1000 Mbps), while standard copper interfaces might run at Fast Ethernet (100 Mbps). Ensure that your switch ports are configured to compatible speeds, or use a multi-rate switch interface.
Look for a device labeled FGE (Fiber Gigabit Ethernet Converter) or CE (Coaxial/Copper-to-Fiber Converter) .