Dell D220p 01 Power Supply Pinout 2 🔥 Bonus Inside

This article outlines the pinout for the , allowing for troubleshooting, DIY cable repair, or repurposing the 220W power supply for other projects. Dell D220P-01 (DA-2 Series) Connector Pinout

Once you bridge the Blue wire to the Ground loop and create stable 12V output trunks, this power brick serves several roles perfectly:

The connector is a Molex-style, dual-row 8-pin interface. Understanding the difference between the (viewed looking directly at the face of the plug pins) vs the internal wire colors is crucial to safely operating the unit. Pin Mapping and Wire Specifications Dell D220p 01 Power Supply Pinout 2

The Dell D220P-01 will not output 12V power simply by plugging it into a wall outlet. It requires a "turn-on" signal, just like an internal ATX power supply. Locate (the Remote/PS-ON wire). Locate any Ground pin (Pins 5, 6, or 7).

For DIY use, many users cut the cable to access the internal wires. For high-current applications (over 6A), it is recommended to join multiple wires of the same type (e.g., all three whites for positive) to handle the 18A load safely. This article outlines the pinout for the ,

does not output full power immediately upon being plugged in. To activate the 12V output (changing the status LED from orange to green), the must be shorted to Ground (Pin 6) . Warnings and Compatibility

An authoritative breakdown verified by the Dell D220P-01 Wiring Spec Sheet defines the pins as follows: Remote Sense / Control (+) — Red Pin 2: Ground / Return (-) — Black Pin 3: Ground / Return (-) — Black Pin 4: Ground / Return (-) — Black Pin 5: Remote Sense Ground (-) — Blue Pin 6: +12V DC Output — White Pin 7: +12V DC Output — White Pin 8: +12V DC Output — White Pin Mapping and Wire Specifications The Dell D220P-01

If you kept the original plug, bridge directly to any of the Ground pins ( Pin 5, 6, or 7 ) using a jumper wire.

If attempting to use this with a custom board, ensure your wiring matches the pinout above exactly. An incorrect connection on Pin 1/5 can cause the PSU to stay in standby mode.