Wit 122-ufs V7.03 Driver

Locate the v7.03 setup file from a trusted repository like DriverIdentifier.

Once connected, the WIT 122-UFS works like a second keyboard. Here's how to use it:

is the most widely documented stable driver, supporting Windows 7 through Windows 10 (64-bit). It is often identified by the Hardware ID USB\VID_05FE&PID_1010 Performance Feedback wit 122-ufs v7.03 driver

When configuring the WIT 122-UFS device, Windows may flag it with a yellow exclamation mark in the Device Manager under "Unknown Devices". Follow these steps to systematically install version 7.03. Method 1: Using the Automated Driver Package

Because the scanner works as a standard HID keyboard, no dedicated “v7.03” driver is required. For almost all use cases, the device operates using the operating system’s built‑in USB keyboard driver. Locate the v7

static struct pci_device_id wit_ufs_ids[] = PCI_DEVICE(0x1B4B, 0x1220), .driver_data = WIT_UFS_V703 , /* sentinel */ ; MODULE_DEVICE_TABLE(pci, wit_ufs_ids);

Users in community forums such as Spiceworks have noted that this scanner often shares internal components with other brands like TaoTronics (specifically the TT-BS003 model), meaning those manuals or drivers may occasionally work as substitutes if the original is unavailable. Troubleshooting & Installation Tips It is often identified by the Hardware ID

Based on the naming convention , this device is most likely a USB-to-Serial (UART) adapter utilizing a CH340 or Silicon Labs CP210x chipset, commonly used for programming microcontrollers (like Arduino) or connecting legacy industrial hardware.

The is the essential software required to connect, configure, and operate the classic WIT 122-UFS barcode scanner on modern operating systems . Because this legacy hardware lacks automated plug-and-play support on newer platforms like Windows 10 and Windows 11, installing the correct version 7.03 driver is critical to ensure data transfers cleanly into your Point of Sale (POS) or inventory systems.

| Error Message | Probable Cause | Solution | | :--- | :--- | :--- | | | USB port power delivery issue. | Use a powered USB hub or change to a rear motherboard USB port. | | "The driver is not intended for this platform" | 32-bit vs 64-bit mismatch. | Ensure you downloaded the x64 version of v7.03. | | "Driver is unsigned" | Windows Secure Boot is active. | Permanently disable Secure Boot in BIOS, or re-enable test signing mode ( bcdedit /set testsigning on ). | | "WIT Suite cannot detect box" | COM port number too high (>16). | In Device Manager, change COM port to COM3-COM8 via Port Settings → Advanced. | | USB device resets during UFS read | Outdated USB host controller driver. | Update chipset and USB 3.0 eXtensible Host Controller drivers from your motherboard vendor. |