Xc2003 Controller Manual [work] -

Route high-voltage motor power cables away from low-voltage sensor lines to eliminate electromagnetic noise. Use shielded cables for sensor connections.

Replacement interface sticker/keypad for controller (Part #1626850001 or 1626850006) ~$49 – $54

Adjust the sensitivity knob on the physical sensor until its indicator light switches states precisely at the edge of the mark. 6. Troubleshooting and Error Codes

| Alarm / Warning | System Response | | :--- | :--- | | High temperature engine coolant | Warning followed by shutdown | | High temperature compressor oil | Warning followed by shutdown | | Engine oil pressure | Warning followed by shutdown | | Low fuel level | Warning | | High DPF soot level | Warning, may require regeneration | xc2003 controller manual

Displays the target cutting or feeding length in millimeters.

: Adjusting parameters like the Diesel Exhaust Fluid (DEF) level alarm requires the insertion of a physical Service Key to access protected engine parameters (Menu 700 000).

Alternatively, if you're looking for the I can help you refine your search to find the specific version for your machine. XC2003 Controller Overview and Fault Codes | PDF - Scribd Route high-voltage motor power cables away from low-voltage

The Atlas Copco XC2003 Go to product viewer dialog for this item.

The Xc2003 features a straightforward, tactile button layout, making navigation simple and efficient even in challenging conditions. The physical buttons are well-defined and include:

| Symptom | Likely Cause | Solution | |---------|--------------|----------| | No LEDs lit | Power missing or reversed | Check 24V supply and wiring | | ERR LED flashing | Program error or watchdog timeout | Connect XC‑Studio, read error log | | No communication | Wrong baud rate or address | Verify DIP switch settings | | Analog input reads 0V | Sensor not powered or wiring loose | Check sensor supply and terminal connection | Alternatively, if you're looking for the I can

The interface is designed for easy navigation through several main views:

Use the arrow buttons to adjust the pressure set point and press "Enter" to confirm.