You must perform a System Check at the start of every shift, or if the ambient temperature shifts significantly.
Inspect the thin Kapton window membrane daily for punctures. Replace torn window films immediately to keep dust out. Troubleshooting Codes Symptom / Error Probable Cause Corrective Action Contaminated window or sample Clean window; retry with fresh reference block. Yellow Warning Light Shutter failed to close fully Power down immediately; inspect for debris. No Power Depleted or unseated battery Re-seat the battery pack or swap for a charged pack. High Error Bars Insufficient testing duration Extend the analysis count time by 10–15 seconds. 💾 Data Transfer and Reporting
| Common Issue | Possible Cause & Resolution | | :--- | :--- | | | The screen freezes on a "Please wait" message and the instrument won't initiate a test. Initial troubleshooting often involves restarting the device. If the issue persists, contacting technical support (e.g., at 021-68654588) is recommended. | | Unit won't turn on | The battery may be completely drained, or the system may be locked. Try charging the battery or performing a system reset . Your vendor can provide instructions on locating and pressing the reset button. |
. However, always point the analyzer away from yourself and others during testing. Niton Xlt 898 User Manual
The Niton XLt 898 is a tank of a machine. It is built to last, but it requires proper stewardship. Whether you are calibrating the detector or setting up the data export settings, the is the blueprint for success.
Launch the proprietary software PC application.
Replace with a freshly charged battery pack. Check electrical contacts for debris. Contaminated or dirty window You must perform a System Check at the
The (often referred to as the XLt 898He) is a high-performance, handheld X-ray fluorescence (XRF) analyzer produced by Thermo Scientific. It is designed primarily for the non-destructive analysis of metal alloys, specifically capable of quantifying light elements like Aluminum (Al), Silicon (Si), and Magnesium (Mg) that were previously difficult for portable units to detect. 1. Key Features & Specifications
The Niton XLt 898 emits X-rays when the shutter is open.
operates via an advanced, low-power X-ray tube excitation source rather than a radioactive isotope. This design offers enhanced speed and lower long-term regulatory oversight. However, ionizing radiation is present during active deployment, making safety compliance mandatory. Maximum Exposure Metrics High Error Bars Insufficient testing duration Extend the
Turn on the analyser, navigate to the data settings tab, and click within the PC application.
Before performing analysis, the initial setup ensures accurate results and instrument longevity.
Connect the analyzer to a computer using the provided serial or USB interface cable.
Use the Niton Data Transfer (NDT) software to download results to a PC via the RS-232 serial cable or optional Bluetooth. Technical Resources Thermo Niton XLT 898: Portable Alloy Analyzer (X-Ray tube)
: High-performance Si-PiN detector, Peltier cooled for stability.