V2000-c User Manual ((top)) -

Supports RFID card only , PIN only , or Card + PIN for enhanced security.

All programming is done using the Master PIN, which is by default. 4.1 Enter Programming Mode

For more information on the manual or to find specific variants, check the V2000-C manual download on .

Open a browser and enter the IP. Use the default credentials found on the unit's sticker (usually admin / password or similar). v2000-c user manual

You can control exactly how users authenticate at the door. Enter programming mode and select one of the following configurations:

Now you are ready to install, operate, and maintain your device with confidence.

Thank you for purchasing the . This device is engineered for professional-grade data collection and environmental monitoring. Please read this manual thoroughly before operation to ensure safety and optimal performance. Supports RFID card only , PIN only ,

The V2000-C writes high-bitrate 4K video. A card formatted in a PC (exFAT) may cause skipping. Use the in-camera format option found in Menu > System > Format.

If the keypad is unresponsive or the master PIN is forgotten, you may need to reset it. 6.1 Restore Factory Default Enter programming mode (using default 1234 if necessary). Press [8] [6] .

Locate the and move the plastic shorting bridge from its default pins 1 and 2 over to pins 2 and 3 . Open a browser and enter the IP

Invalid command, sequence error, or read failure.

This is a specific reference to a model of access control controller, identified by the numbers NC/RI in many software configuration manuals. These guides show you how to integrate this specific hardware model into a larger security management system, such as AxxonSoft's ACFA Intellect PSIM software.