Weltouch Cy-210b Manual [hot] <EASY - 2026>

: Wire a single-level foot switch directly between the Common screw and the Start 1 terminal.

Clean or replace pitted welding tips; increase incoming utility voltage.

: Set the cooling cycles to prevent extreme heat soak before the main weld current.

: Reconfigures the auxiliary circuit to act as a flicker output (alternating Weld ON / Cool OFF cycling). Troubleshooting and Fault Codes weltouch cy-210b manual

Install the controller on a firm, level surface away from water or combustible materials.

: 5.0 kA to 40.0 kA (scale adjustable via synchronized panel button commands).

One second. Two seconds. The fan whirred, unchanged. Five seconds. Eight seconds. At the nine-second mark, the green power light began to flash rapidly. Ten seconds. : Wire a single-level foot switch directly between

If you see “Err-C” : The calibration weight is wrong or not stable. Repeat from step 1.

A: No, the CY-210B is specifically designed for .

: Set the pre-heating profile. This burns away minor plating scales or surface oxidation. : Reconfigures the auxiliary circuit to act as

The internal lithium battery (BR 1/2AT2N) has a data holding period of approximately 5 years. Troubleshooting Common Errors

The CY-210B uses an LED display system. The front panel consists of: