Zkteco Ua300 Factory Reset [patched] -

Select or Advanced Settings (the name varies by firmware version). Find and select Factory Reset .

Click . The software will send a command to wipe the device configuration. Method 3: Overcoming an Admin Lockout (Forgot Password)

If the UA300 is connected to your local network, you can trigger a factory reset remotely using your computer. Step 1: Connect to the Device Open your or ZKTime 5.0 software. Go to the Device management section. Ensure the UA300 status shows as Connected . Step 2: Clear Device Data Click on AC Management or Device Control . Look for the Clear Data or Initialize Device tool. zkteco ua300 factory reset

The software will send a command script to the UA300 over the network to wipe the device and reboot it.

The tool generates a temporary master password based on that exact minute. Select or Advanced Settings (the name varies by

If the device is completely bricked, frozen on the boot screen, or unresponsive to software commands, a hardware power-cycle or button reset is required.

(functions.RelatedSearchTerms)

If you cannot access the menu because the previous administrator left or forgot the password, you do not need to perform a full physical wipe immediately. You can clear the administrator privileges using a master security key calculator. Step 1: Note the Device Time

The is a fingerprint-based access control and time attendance terminal. It supports: The software will send a command to wipe

Go to the section and ensure the UA300 status shows as "Connected". Select the specific UA300 device from your list. Look for the Device Control or AC Parameters tab. Click on Clear Data or Initialize Device .

Press the tamper switch quickly within 30 seconds of the beep to reset the admin password to the default (typically 1234 or 12345 ). Default/Common Setting Default IP 192.168.1.201 Default Admin ID 8888 Default Password 1234 or 12345