Xnx Universal Transmitter Quick Start Guide __top__

From the main menu, navigate to the Sensor Menu to verify that the transmitter has recognized the correct cartridge type (Electrochemical, Infrared, or Catalytic Bead).

: Enter the default passcode 0000 using [ ▲ ] or [ ▼ ] .

[ XNX MAIN TERMINAL BLOCK ] +-----------------------------------------------------+ | Terminal 1 | Terminal 2 | Terminal 3 | Earth | | 24V DC + | Common | 4-20mA Out | Ground | +--------------+--------------+------------+----------+ | | | | v v v v (Positive) (Negative) (Signal) (Shield) Power and Signal (4-20mA) Wiring

Once powered, the backlit LCD comes to life. Instead of opening the unit, you use a magnetic wand to navigate the menus through the glass. You enter the factory default passcode 0000 to access configuration. Xnx Universal Transmitter Quick Start Guide

Once stabilized, the unit displays the current gas concentration, gas type, and unit of measurement. 5. Non-Intrusive Magnetic Interface Operation

Install the unit vertically with the sensor pointing directly downward to prevent water or debris accumulation.

Use the integrated mounting lugs to secure the unit to a wall or pipe. Ensure the sensor is pointing downward to prevent water or dust accumulation. Wiring: Open the housing using the provided hex key. From the main menu, navigate to the Sensor

Touch the wand to the four magnetic switches on the glass display: Up , Down , Escape (X) , and Enter (✓) .

: Basic troubleshooting steps to help users resolve common issues that might arise during initial setup or use.

Steps progress naturally:

Remove the gas and exit the menu to return to monitoring mode. 6. Common Fault Codes Sensor missing or disconnected. F161: Calibration required or failed. W001: Warning that the unit is in "Inhibit" mode. Safety Warnings

A of the calibration process for specific gases Troubleshooting steps for specific error codes