Zte F689 Bridge Mode · Easy

Elias closed the terminal window. The warden had been fired. The king sat on his throne.

A router with a WAN (Internet) port to connect to the ONT. Steps to Configure ZTE F689 Bridge Mode

Power cycle both devices. Turn them off for two full minutes to clear the ARP cache at your ISP's central switch, then turn them back on starting with the ZTE device.

Depending on your ISP's firmware, Bridge Mode might be a simple toggle or hidden behind advanced settings. Access the Admin Interface : Connect a computer directly to the via Ethernet and navigate to its IP address (usually 192.168.1.1 192.168.0.1 ) in a web browser. Locate WAN Settings : Navigate to Toggle Bridge Mode Standard Method : Look for a Bridge Mode Zte F689 Bridge Mode

Click or Add to populate a blank configuration profile. Apply these explicit settings:

Input your administrator credentials on the landing screen and click . 3. Modifying the WAN Settings for Bridge Mode

If an SSL security warning appears, click and choose Proceed to Address (unsafe) . Elias closed the terminal window

Note: Alternatively, if the device does not allow you to modify the existing profile, you can delete the routing profile and click , choosing Bridge as the Link Type. Step 5: Bind the Bridge Mode to a Physical Port

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Check the box next to (it is best practice to use LAN Port 1 for the bridge connection). A router with a WAN (Internet) port to connect to the ONT

He navigated to the tab, his cursor hovering over the WAN settings. There it was, buried under layers of hidden menus: Connection Mode .

Save the changes and restart both devices. Your new router will now receive a public IP address directly from your ISP. Troubleshooting Common Issues No Internet Access on the New Router

If "Bridge" is grayed out or hidden, some users use "Inspect Element" in the browser to manually change the dropdown value. :