: Features a 72-bit/1K BCH ECC engine to handle the high error rates of modern flash chips. Integrated Crystal
If you require specialized drive functions, the Alcor configuration panel offers advanced operational modes:
Because you cannot easily open the plastic casing of your USB drive without damaging it, you should use a software tool called or Flash Drive Information Extractor (Flash Drive Information Extractor) . How to check: Download and launch ChipGenius (run as Administrator).
Communicates directly with the microcontroller chip and the NAND flash memory. It rewrites the drive's firmware, scans for structural bad sectors, maps them out, and builds a brand-new file system structure from scratch. When Do You Need the AU6989SN MPTool? Alcor Micro Au6989sn Mptool
: If a standard LLF fails, you can try adjusting the ECC (Error Correction Code) setting. This is found in the same "Low Level Format" settings area. In some cases, setting the ECC to 12 can allow the tool to successfully format a drive with a high number of bad sectors.
Locate the main executable file, usually named AlcorMP.exe , AlcorMP_FC.exe , or LoadDriver.exe . Right-click the application and select Run as administrator .
Lower the clock frequency in the settings or switch the configuration to prioritize stability over speed. : Features a 72-bit/1K BCH ECC engine to
: Set hard software-level write protection that cannot be removed by standard formatting tools. am.adianshi.com Technical Specifications ECC Optimization
This guide covers the process of "re-flashing" (mass production) your AU6989SN USB drive.
Disconnect all other unnecessary USB flash drives or external hard drives from your computer to avoid formatting the wrong device by mistake. Communicates directly with the microcontroller chip and the
After configuring the settings, click to return to the main window. Then, click the "Start" button.
+-------------------------------------------------------------+ | AlcorMP (Mass Production Tool) | +-------------------------------------------------------------+ | [Port 1] [=======> Ready: 16GB Flash detected <=======] | | [Port 2] [ Empty ] | | | | [ Setup (S) ] [ Start (A) ] [ Refresh (G) ] | +-------------------------------------------------------------+ 4. Adjust the Settings (Setup)