: Discontinue use if you notice burning smells or if the power cord feels excessively hot. The Warehouse Group
Debris from water tanks can clog internal components. Isolate the system, depressurize the lines, remove the controller inlet flange, and clear out any trapped sediment.
This is typically caused by an ungrounded system loop. Ensure the FG (Frame Ground) pin is securely bonded to earth ground. Additionally, keep low-voltage analog signal wires routed away from high-voltage AC lines or electric motors.
Store the lid upside down on top of the cooker to prevent the gasket from absorbing odors or losing its shape.
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Zenox Zpc-ep1 Manual
Proper physical alignment and electrical installation protect internal sensors from premature wear and prevent localized system leaks. 1. Hydraulic Alignment Install the Zenox Zpc-ep1
Electrical wiring should comply with local national wiring regulations and be performed by a licensed electrician.
Screw the bottom 1-inch inlet directly into the top discharge port of your water pump. Sealing:
Consult the manufacturer's troubleshooting guide. Common errors often relate to pressure drops, power surges, or sensor disconnections. Safety Precautions : Discontinue use if you notice burning smells
Inspect all downstream pipework for slow leaks. Alternatively, install a tiny 2-liter pressure accumulator tank after the controller outlet to absorb micro-pressure losses. 3. Pump Runs Continuously and Will Not Shut Off
Inside the Zenox Control Center, navigate to the tab.
To start cooking later, press "Delay Timer" and set the desired wait time before the cycle begins. Safe Steam Release
Ensure the silicone sealing ring is seated firmly in the lid's gasket holder. This is typically caused by an ungrounded system loop
Install the controller vertically. It must be mounted directly on top of the pump discharge outlet or in the discharge line before the first tap.
Click to store these settings directly onto the ZPC-EP1 hardware memory, removing any reliance on temporary software profiles. 8. Troubleshooting FAQ
To ensure safe and reliable operation, please observe the following precautions:
Check if your rainwater tank is empty or if the suction line valves are closed. Verify that the pump is properly primed. To manually reset the controller, press and hold the red "Reset" button on the interface panel for 5 seconds until the status lights clear. 3. Rapid Cycling (Pump Turns On and Off Frequently)
