Before programming a new installation, it is recommended to clear out factory test configurations. Hold down the system programming buttons (typically marked as P1 or SET ) for approximately 5-10 seconds until the display flashes or registers a reset state. Programming Travel Limits
Before mounting, ensure the following conditions are met to avoid warranty issues: - PROBO - PR60 R - PR80 R - montaza.lv
Regular maintenance is essential for safe and long-lasting operation. Perform the following checks periodically:
In case of a power failure, pull the release cord downward to disengage the motor and operate the door manually. 5. Maintenance Guidelines Before programming a new installation, it is recommended
To find the address and contacts of the nearest authorized service center for professional repairs, please visit our website or scan the QR code on the back cover of your product packaging.
Before beginning installation, perform the following checks to ensure a smooth and safe process:
: Operates on a 230V AC mains supply with a 24V DC motor. Perform the following checks periodically: In case of
Mount the operator onto the runner by introducing the shaft into the block hole without forcing it.
[ Lintel Bracket ] | V ==============================[ Drive Rail / Chain ]============================== | V [ Motor Head (PR70) ] <--- [ Power Cord ]
Dependent on the rail length selected (standard up to 2.4m, extended up to 3.1m) Operational Temperature: -20°C to +55°C Mechanical Pre-Checks Before beginning installation
(Optional) Connect a wired push-button if you prefer manual control inside the garage. 4. Programming and Limits
Fit safety photocells to comply with European safety standard EN 12453. 2. Pre-Installation Checklist Required Tools Impact drill and masonry bits Spirit level Socket wrench set (10mm, 13mm) Wire cutters and strippers Flathead and Phillips screwdrivers Door Inspection Ensure the garage door opens smoothly by hand.
Place a solid object (such as a 50mm high block of wood or a packing box) flat on the floor directly beneath the path of the garage door. Activate the door to run in the downward close direction.
: Fix the closing mechanical stop by pulling the release lever to close the door, resting the stop against the drive carriage, and securing it. Repeat the process for the opening stop. Peiter Automatic Initial Setup & Programming