The lock will beep once for a successful button press and twice for a successful command. A long beep indicates an error.
If your lock is new or you are performing a factory reset, you must initialize the system.
Flip the internal privacy switch to the "Red" or locked position. This disables all external digital inputs (PIN, Fingerprint, Card), allowing entry only via the physical mechanical key. 6. Troubleshooting & Battery Management Low Battery Warning
Standard models require 4x AA Alkaline Batteries . Note: Do not use rechargeable batteries as their voltage output is often too low for consistent performance. Zeus Z3 Digital Lock Manual
Occasionally, you may encounter minor issues, but Zeus has built-in fail-safes to ensure you are never locked out.
If an RFID card is lost or you want to revoke someone's access, you can delete them individually. Go into programming mode, select 'Delete User', and enter the specific PIN, Fingerprint ID, or swipe the card to wipe it from the lock’s memory. Daily Operation and Maintenance
A: Yes, using the physical reset button will wipe all data and restore factory settings. The lock will beep once for a successful
If you provide me with more information about your lock, such as the model or manufacturer, I may be able to provide more tailored guidance.
Set the latch backset to either 60mm or 70mm based on your door. Insert the latch into the edge bore and tighten the screws. Ensure the "Up" arrow on the latch faces the exterior of the door.
A: Only registered RFID cards specifically programmed into the lock's system will work. The lock supports MIFARE® standard cards. Flip the internal privacy switch to the "Red"
| Function | Steps | | :--- | :--- | | | Master PIN + # → 1 → # → place finger on sensor 3x → # | | Add RFID Tag | Master PIN + # → 2 → # → tap tag on outdoor unit → # | | Add User PIN (6-10 digits) | Master PIN + # → 3 → # → enter new PIN → # → repeat PIN → # | | Delete Single User | Master PIN + # → 4 → # → scan fingerprint / enter PIN / tap tag → # | | Delete All Users | Master PIN + # → 0000 → # → confirm with Master PIN → # |
What you are stuck on (Installation, App integration, or Programming) Any error codes or beep patterns the lock is giving off