Eliwell Sb655 C Manual __top__

Check door seals, clean condenser coils, and monitor compressor. Low Temperature Alarm

Check digital inputs configured as external alarms (H11...H14). Open door alarm Check digital input status for door sensors (H11...H14). 5. Summary of Key Features

Typically involves holding specific key combinations to enter folders like PAR (parameters) or FnC (functions). Troubleshooting & Configuration Tips

Install a 0.5A fast-acting fuse on the live (L) line of the controller's power supply. 3. User Interface and Navigation

Disclaimer: This article is for informational purposes. Always consult a licensed refrigeration technician before modifying electrical connections or gas pressures. Product names are trademarks of Schneider Electric. eliwell sb655 c manual

Connect line and neutral to the designated power terminals. Probes (NTC / PTC): Pb1 (Room Probe): Measures ambient storage temperature.

Time delay before a temperature alarm registers and triggers relays. 5. Advanced Applications and Control Logic Compressor Protection Modes

Press to view or modify the target temperature Setpoint.

Is your system configured for a or a freezer ? Check door seals, clean condenser coils, and monitor

230Vac ±10%, 50/60Hz (depending on the specific model variant)

Evaporator fan shuts off if evaporator probe exceeds this value. High Alarm Threshold LAL to 150°C

I can provide the exact wiring schematic references or specific parameter values for your setup. AI responses may include mistakes. Learn more Share public link

Support for both compressor and primary water pump VFDs. Free Cooling/Heating: Adaptive energy-saving functions. 2. Installation and Mechanical Mounting

Increases values in programming mode. Press and hold for 5 seconds to initiate a manual defrost cycle.

When a fault occurs, the Eliwell SB655 C flashes an alarm code on the screen and triggers the internal buzzer or alarm relay.

Connects to monitoring systems like Eliwell Televis. Technical Data Power Supply: 230Vac ±10%, 50/60Hz (model dependent). Power Consumption: 4.5 VA maximum. Display Range: -50.0°C to +110.0°C. Front Panel Protection: IP65 water and dust resistance. Dimensions: Standard 32x74 mm front panel mounting. 2. Installation and Mechanical Mounting