// Stop digitalWrite(MOTOR_A_IA, LOW); digitalWrite(MOTOR_A_IB, LOW); delay(500);
Wire an external battery pack or power supply (e.g., a 2S LiPo or 4 x AA battery holder) to the EXT_PWR terminals [1]. Ensure correct polarity (+ to +, - to -).
📉 One of the cheapest ways to control 4 DC motors. hw 130 motor control shield for arduino datasheet free
Up to 2 x 5V hobby servo motors connected to Arduino's high-resolution timers [1] 🔌 Pinout and Interface Layout
The easiest way to program the HW-130 is by using the legacy . Do not use the V2 library, as it is designed for I2C-controlled shields. 1. Library Installation Open the Arduino IDE. Up to 2 x 5V hobby servo motors
AF_DCMotor motor1(1); AF_DCMotor motor2(2);
Built-in thermal shutdown and internal ESD protection diodes Pinout and Interface Layout Library Installation Open the Arduino IDE
The HW-130 shield allows you to drive multiple DC motors, stepper motors, and servo motors simultaneously by offloading the high-current demands from the Arduino microcontroller. Power & Voltage Ratings 4.5V to 25V DC
The shield plugs directly onto the headers of an Arduino Uno or Mega. Motor Connections