The manual provides detailed tables for feedrates. For the TF Plus, pay special attention to the section on Automatic Acceleration/Deceleration . The manual explains how the control rounds sharp corners (G09 or G61) to prevent machine gouging.
Pauses axis movement for a specified duration to clear chips or finish faces. Return to Machine Zero
Automatically adjusts RPM based on the current cutting diameter. Direct RPM Control
Provide these details, and I can generate the exact block format or troubleshooting steps you need. Share public link fanuc series oitf plus programming manual
The "TF Plus" designation indicates an evolution from the standard TF model. The manual highlights features specific to the Plus hardware and software:
G01 X(U)__ Z(W)__ F__;
When utilizing Constant Surface Speed ( G96 ), always define a maximum spindle speed clamp using G50 SXXXX ahead of time. Failing to do so will cause the chuck RPM to spike dangerously high as the tool cuts closer to X0 (the centerline). The manual provides detailed tables for feedrates
The G71 cycle removes material in linear steps parallel to the Z-axis (O.D. or I.D. turning). It uses a two-line block format on FANUC systems. G71 U0.1 R0.05 G71 P100 Q200 U0.02 W0.005 F0.012 Use code with caution.
The "Plus" series often utilizes MANUAL GUIDE i , which allows for conversational, graphical programming without needing deep G-code knowledge. Advanced Programming Supplements
| G Code | Group | Function | Modal | |--------|-------|------------------------------------|-------| | G00 | 01 | Positioning (Rapid Traverse) | Yes | | G01 | 01 | Linear Interpolation (Feed) | Yes | | G02 | 01 | Circular Interpolation (CW) | Yes | | G03 | 01 | Circular Interpolation (CCW) | Yes | | G04 | 00 | Dwell (P or X/U address) | No | | G10 | 00 | Programmable Data Input | No | | G18 | 16 | Xp-Zp Plane Selection (Default) | Yes | | G20 | 06 | Inch Input Mode | Yes | | G21 | 06 | Metric Input Mode | Yes | | G32 | 01 | Thread Cutting | Yes | | G40 | 07 | Cutter Compensation Cancel | Yes | | G41 | 07 | Cutter Compensation Left | Yes | | G42 | 07 | Cutter Compensation Right | Yes | | G50 | 00 | Coordinate System Setting | No | | G70 | 00 | Finishing Cycle | No | | G71 | 00 | Stock Removal in Turning (Type I/II)| No | | G72 | 00 | Stock Removal in Facing | No | | G76 | 00 | Multiple Threading Cycle | No | | G83 | 09 | Deep Hole Peck Drilling (Z-axis) | No | | G96 | 13 | Constant Surface Speed Control ON | Yes | | G97 | 13 | Constant Surface Speed Control OFF | Yes | | G98 | 05 | Feed per Minute (mm/min) | Yes | | G99 | 05 | Feed per Revolution (mm/rev) | Yes | Pauses axis movement for a specified duration to
The programming manual is structured around several critical domains that allow a programmer to master the machine: Coordinate Systems and Motion Control
By referring to these resources, users can gain a deeper understanding of the Fanuc Series OITF Plus and improve their skills in programming and operating the system.