Convo Inverter Cvf G3 Manual _hot_ 〈High-Quality〉

Set in seconds (e.g., 10.0s). Time to ramp from 0Hz to max frequency. Deceleration Time 1

| Error Code | Name | Likely Cause (Per Manual) | Solution | | :--- | :--- | :--- | :--- | | | Overcurrent at acceleration | Short circuit, wrong motor parameters, or too fast ramp | Increase acceleration time (F2.00). Check motor insulation. | | Err.OC2 | Overcurrent at deceleration | Braking resistor missing, regenerative overvoltage | Add braking resistor or increase decel time (F2.01). | | Err.OC3 | Overcurrent at constant speed | Load shock, mechanical jam | Reduce load or check gearbox. Enable torque limit (F7.xx). | | Err.Ou1 | Overvoltage | Inverter braking too much energy | Increase decel time or install braking unit. | | Err.Ou2 | Undervoltage | Input power sag, missing phase on R,S,T | Check incoming supply voltage and wiring. | | Err.OH | Overheat | Fan failure, ambient too high ( >40°C) | Clean heatsink, replace fan. Reduce carrier frequency (F0.19). | | Err.SC | Short circuit | Motor wiring short to ground | Use a megger to test motor and cable. | Convo Inverter Cvf G3 Manual

Error-code table (common)

Using the keypad, he bumped the acceleration time to fifteen seconds and adjusted the torque boost. He gave the manual a final pat, closed the cabinet door, and hit the start button. Set in seconds (e

0: Keypad Digital Setting1: AI Analog Input (External Potentiometer) Acceleration Time 1 Check motor insulation

Typical file name format: CVF-G3 Series Manual V2.0.pdf

Maintain 5.0 bar of pressure in a water pipe using a 4-20mA pressure sensor.